;

MICHELL TECNOARM

The Tecno Arm “A” is a fundamental mechanical rebuild of the well-known RB250 tonearm, to which is added monolithic wiring of the highest quality.

» Mer om produktet

The arm tube is bead-blasted and perforated, which disperses structural resonances and yields a lower effective mass. The arm wand is internally damped to reduce resonance further, and the headshell is machined flat, to allow true azimuth relative to the bearing cradle. After modification the bearings are re-adjusted for highest possible performance, according to original Rega procedures

» Tekniske data

One-piece perforated arm casting with internal foam damping

Proprietary silver litz cable in a continuous run from cartridge to amplifier
PTFE dielectric, metal braided shielding, separate ground wire
Silver-plated cartridge clips and phono plugs
Two counterweights, matching cartridges of 4-7g and 7-13g
Vertical tracking force adjuster in steps of 0.1g
Three point vertical tracking angle adjuster
Finger locknut for easy arm removal or VTA adjustment
Three point fixing
The Techno Arm “A” is also available in black.

Del på: Del på Facebook Del på Twitter
×

Abonner på vårt nyhetsbrev

Motta vårt nyhetsbrev med nyheter og tilbud.